Seismic Zone Map

Seismic Design Categories

Seismic design categories define the earthquake risk level for a building site and prescribe corresponding structural requirements. The International Building Code assigns categories A through F based on the mapped spectral response acceleration and the site soil classification. Higher categories require progressively more robust structural systems, connection detailing, and quality assurance measures. Understanding seismic design category is essential for architects, engineers, and contractors working in seismically active regions.

Seismic Design Category A represents areas with very low earthquake risk where the mapped short-period spectral response acceleration is less than 0.167g. No specific seismic design provisions are required beyond basic structural integrity. Category B applies to moderate-risk areas with accelerations between 0.167g and 0.33g, requiring basic seismic detailing such as anchor bolt connections between foundations and walls. Category C covers areas with spectral accelerations between 0.33g and 0.50g and requires more extensive lateral force-resisting systems, continuous load paths, and specific connection detailing for shear walls and diaphragms.

Category D applies to high seismic risk areas, including much of coastal California, the Pacific Northwest, the New Madrid seismic zone, and parts of the Intermountain West. Category D requires complete seismic force-resisting systems designed by licensed structural engineers, special moment frames or shear walls, and special inspections of critical connections. Categories E and F represent the highest risk, with near-source effects from active faults. Category E applies within approximately 6 miles of major active faults in high-seismicity regions. These categories require the most rigorous design, detailing, and inspection requirements, including additional redundancy and overstrength factors. Critical facilities like hospitals and emergency response centers must meet higher standards even in lower seismic categories.

Seismic Design Category Reference

CategoryRisk LevelSpectral Acceleration (Ss)Structural RequirementsExample Regions
AVery Low< 0.167gStandard constructionMidwest, Florida, Texas plains
BLow to Moderate0.167g - 0.33gBasic lateral detailingGreat Plains, upper Midwest
CModerate0.33g - 0.50gEngineered lateral systemAtlantic coast, Colorado plateau
DHigh0.50g - 1.0gFull seismic design, special inspectionCA coast, PNW, New Madrid zone
EVery High (near fault)> 1.0g near sourceEnhanced detailing, redundancyNear San Andreas, Hayward faults
FHigh (poor soil)Varies, site class FSite-specific analysis requiredLiquefiable soils, Bay mud