Concrete mix design is specified by the ratio of cement to fine aggregate (sand) to coarse aggregate (gravel or crushed stone) by volume, along with the water-to-cement ratio (w/c). The w/c ratio is the single most important factor determining concrete strength and durability — a lower w/c ratio produces stronger, denser concrete but is harder to work and place. Standard residential concrete for slabs, footings, and walls is typically 3,000 to 3,500 PSI, achieved with approximately a 1:2.5:3.5 mix ratio and a w/c ratio of 0.45 to 0.50. High-strength concrete for structural columns, bridge decks, and pre-stressed members can exceed 5,000 PSI and requires a w/c ratio below 0.40 along with supplementary cementitious materials like fly ash or silica fume. Air entrainment (4-8%) is required for exterior concrete exposed to freeze-thaw cycles. An 80-pound bag of ready-mix concrete yields about 0.6 cubic feet of cured concrete. A typical 4-inch-thick 10x10-foot slab requires about 1.24 cubic yards of concrete, or approximately 56 bags of 80-pound mix.
| Mix Name | Target PSI | Cement:Sand:Gravel | Water/Cement Ratio | Typical Use |
|---|---|---|---|---|
| Lean Mix | 2,000 - 2,500 | 1:3:5 | 0.55 - 0.65 | Blinding, mass fill, non-structural |
| Standard Residential | 2,500 - 3,000 | 1:2.5:4 | 0.50 - 0.55 | Slabs-on-grade, sidewalks |
| General Purpose | 3,000 - 3,500 | 1:2.5:3.5 | 0.45 - 0.50 | Driveways, footings, walls |
| Structural | 4,000 | 1:2:3 | 0.40 - 0.45 | Beams, columns, retaining walls |
| High-Strength | 5,000 | 1:1.5:2.5 | 0.35 - 0.40 | Bridge decks, pre-stressed, high-rise |
| Very High-Strength | 6,000 - 8,000 | 1:1:2 | 0.30 - 0.35 | Specialty structures, parking decks |
| Mortar (Type S) | 1,800 | 1:3 (cement:sand) | 0.50 - 0.60 | Masonry above grade |
| Grout (Fine) | 2,000 - 3,000 | 1:2.5 (cement:sand) | 0.50 - 0.60 | Filling CMU cells, tile setting |
The water-cement ratio law established by Abrams in 1918 states that concrete strength is inversely proportional to the w/c ratio. Every extra gallon of water per cubic yard increases slump but reduces strength by roughly 500 PSI. Proper curing is equally critical: concrete should be kept continuously moist for at least 7 days to achieve design strength. Curing compounds, wet burlap, or plastic sheeting can all be used. Concrete reaches approximately 50% of its 28-day strength in 7 days and about 70% in 14 days. Hot weather accelerates setting and increases water demand; cold weather slows strength gain and requires heated enclosures or insulating blankets when temperatures drop below 40 degrees F.