How to Insulate Pipes

Overview

Insulating hot water pipes reduces heat loss by 2–4 degrees between the water heater and the faucet, saving energy and delivering hot water faster. Insulating cold water pipes prevents condensation (sweating) that drips onto ceilings and floors, and helps prevent freezing in unconditioned spaces. Foam pipe sleeves are the easiest DIY solution—they slip on and seal with adhesive strips. Budget 1–2 hours for a typical basement or crawl space pipe run.

Tools & Materials

Step-by-Step

  1. Measure and match pipe diameter. Most residential water lines are 1/2-inch or 3/4-inch copper or PEX. Measure the outside diameter with a tape measure or note the size printed on the pipe. Buy insulation that matches—a loose sleeve provides no insulating value.
  2. Clean the pipes. Wipe pipes with a damp rag to remove dirt, oil, and dust. Insulation adhesive will not stick to a grimy pipe. For hot water pipes, wait until the pipe is cool to the touch—otherwise the adhesive melts and fails.
  3. Measure and cut sleeves to length. Measure each pipe section between fittings, elbows, and valves. Cut the foam sleeve with a utility knife or scissors. Cut it about 1/2 inch short so the insulation does not bunch up at fittings. For T-fittings, miter-cut the sleeve ends at 45 degrees so they butt together neatly.
  4. Install sleeves on straight runs. The sleeve has a slit along one side—open it and slip it over the pipe. For self-sealing sleeves, peel the release liner from the adhesive strip and press the two sides together firmly. For non-adhesive sleeves, run duct tape along the seam every 12 inches.
  5. Insulate elbows and bends. Use pre-formed elbow insulation (peel-and-stick miters) or cut a 45-degree miter in straight sleeve sections. Wrap tightly and tape the joint completely. Gaps at elbows lose a disproportionate amount of heat because the water changes direction at the highest turbulence.
  6. Tape all seams and joints. Where two sections of insulation meet at a butt joint, wrap the joint completely with pipe insulation tape. This prevents air gaps that allow condensation on cold pipes. Tape also secures the insulation against sagging over time.
  7. Do NOT insulate within 6 inches of gas water heater flues. Foam insulation is flammable and must be kept at least 6 inches from the flue pipe and draft hood. Fiberglass wrap (non-flammable) can be used for hot water pipes closer to the heater.
  8. Check coverage. Walk the entire pipe run and check for any bare spots, unsealed seams, or gaps. A single gap in an otherwise insulated loop wastes 30% of the insulation benefit.

Tips

Tip 1: Insulating the first 6 feet of hot water pipe from the water heater provides the biggest energy savings—this is where temperature loss is greatest.
Tip 2: For cold water pipes in humid basements, insulation prevents condensation dripping. The foam sleeve keeps moist air from contacting the cold pipe surface.
Tip 3: Near a gas water heater, use 1-inch-thick fiberglass pipe wrap secured with wire or foil tape for the hot water pipe near the flue—it is non-combustible.
Tip 4: Do not wrap insulation over pipe leak stains—fix leaks first. Insulation over a slow leak traps moisture and causes the pipe to corrode faster.
Tip 5: For outdoor or exposed pipes in a crawl space, add a vapor barrier wrap over the foam sleeve to protect against moisture, UV damage, and rodent chewing.